| Problem : |
|
Screw head shears while drilling |
| Remedy : |
|
This happens if high Torgue is set
on the screw gun. |
| |
|
Reduce the Torgue to lower setting
try |
| |
|
|
| Problem : |
|
Screw does not drill in steel purlin |
| Remedy : |
|
Check the torque setting on your screw
gun and increase to higher setting. |
| |
|
Check the RMP of your screw gun.It
should be 2000 RPM. |
| |
|
Check the thickness of steel purlin.It
should be less then the higher drill point. |
| |
|
Check the power supply point. It should
be 5 amps single phase. If more than two machines
are connected to the same source than the supply
point must have a 4 sq mm cable. The screw gun should
have a power card of 2.5 sq mm copper cable. Avoid
longer length of power cable from supply pointis
closer to working site. |
| |
|
|
.gif){kind=small}
Downloads
Contact Us
Trouble Shooting
.gif){kind=small}
Associates
Benefits
Fact Sheet
.gif){kind=small}
Trouble Shooting 
Terminology 
How To Order 
Corrosion 
Warranty Certification